Rca RCU1010RF Manual de usuario descargar pdf (Pagina 6)

Battery Information

Your RCU1010RF Universal Learning Remote with Touchscreen and Built-in RF Transmitter requires

four AAA alkaline batteries (sold separately).

Battery Installation

To install the batteries in the remote:

1. Turn the unit over, push on the tab and slide the cover down.

2. Insert the batteries, matching the batteries to the (+) and (-) marks inside the battery case.

3. Slide the battery cover back into place.

Battery Saver

Your RCU1010RF saves battery power by automatically turning off if any key is pressed for more

than 30 seconds. This saves your batteries should your remote get stuck in a place where the keys

remain depressed, such as under a book or between the sofa cushions.

Code Saver

With the RCU1010RF, you don’t have to worry about losing programmed information when

you change batteries. All programmed parameters are retained indefinitely in the event of

battery replacement.

Power-on Default

When you replace batteries, your RCU1010RF remote always powers on in the TV Mode. If your

TV, VCR or satellite receiver is an RCA, ProScan or GE brand, you may not even need to set

up the RCU1010RF to control it. In these instances, the remote should work as soon as the

batteries are installed.

RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 77 78

Sin comentarios

Rca RCU1010RF Manual de usuario Pagina 6